Coil spring
In this manual: Coil spring
4steps
~24min
2/5difficulty
Done 0 of 4
Exploded View

1. Upper rubber seat 2. Coil spring 3. Lower rubber seat 4. Rear suspension beam
Removal and Installation
REMOVAL
- Remove the wheel and tire assemblies using power tool. Refer to WT "Adjustment".
- Position a suitable jack under rear suspension beam.
CAUTION:
- Place the jack in the center of the suspension beam.
- Do not damage the suspension beam with jack.
- Remove the lower shock absorber bolts. Refer to RSU "Removal and Installation".
- Slowly lower jack, then remove upper rubber seat, coil spring and lower rubber seat from rear suspension beam.
INSTALLATION
Installation is in the reverse order of removal.
- Install the lower rubber seat (A) to the rear suspension beam mounting hole (B).
- Match up lower rubber seat indentions and rear suspension beam grooves and attach.

Inspection
INSPECTION AFTER REMOVAL
Check rubber seat and coil spring for deformation, crack, and damage. Replace it if necessary.
INSPECTION AFTER INSTALLATION
Check wheel alignment. Refer to RSU "Inspection".
Was this page helpful?