Brake lining
In this manual: Brake lining
6steps
~36min
2/5difficulty
Done 0 of 6
BRAKE LINING : Inspection and Adjustment
INSPECTION
Brake Lining
- Remove plug from back plate. Refer to BR "Exploded View".
- Check brake lining wear thickness (A) from an inspection hole on back plate. Check using a scale necessary.
(A) : Refer to BR "Rear Drum Brake".

ADJUSTMENT
Burnish contact surfaces between brake lining and brake drum according to the following procedure after refinishing or replacing brake lining, or if a soft pedal occurs at very low mileage.
CAUTION:
- Be careful of vehicle speed because the brake does not operate firmly/securely until brake lining and brake drum are securely fitted.
- Only perform this procedure under safe road and traffic conditions. Use extreme caution.
- Drive vehicle on straight, flat road.
- Depress brake pedal with the power to stop vehicle within 3 to 5 seconds until the vehicle stops.
- Drive without depressing brake for a few minutes to cool the brake.
- Repeat steps 1 to 3 until brake lining and brake drum are securely fitted.
Was this page helpful?