Door lock and unlock switch
Component Function Check
1.CHECK FUNCTION
- Select DOOR LOCK of BCM using CONSULT.
- Select CDL LOCK SW, CDL UNLOCK SW in DATA MONITOR mode.
- Check that the function operates normally according to the following conditions.

Is the inspection result normal?
YES >> Main power window and door lock/unlock switch is OK.
NO >> Refer to DLK "Diagnosis Procedure".
Diagnosis Procedure
Regarding Wiring Diagram information, refer to DLK "POWER DOOR LOCK SYSTEM : Wiring Diagram".
1.CHECK DOOR LOCK AND UNLOCK SWITCH INPUT SIGNAL
- Turn ignition switch OFF.
- Disconnect main power window and door lock/unlock switch connector.
- Check signal between main power window and door lock/unlock switch harness connector and ground using oscilloscope.

Is the inspection result normal?
YES >> GO TO 3.
NO >> GO TO 2.
2.CHECK DOOR LOCK AND UNLOCK SWITCH CIRCUIT
- Disconnect BCM connector.
- Check continuity between BCM harness connector and main power window and door lock/unlock switch harness connector.

- Check continuity between BCM harness connector and ground.

Is the inspection result normal?
YES >> Replace BCM. Refer to BCS "Removal and Installation".
NO >> Repair or replace harness.
3.CHECK DOOR LOCK AND UNLOCK SWITCH GROUND
Check continuity between main power window and door lock/unlock switch harness connector and ground. 
Is the inspection result normal?
YES >> GO TO 4.
NO >> Repair or replace harness.
4.CHECK DOOR LOCK AND UNLOCK SWITCH
Refer to DLK "Component Inspection".
Is the inspection result normal?
YES >> GO TO 5.
NO >> Replace main power window and door lock/unlock switch. Refer to PWC "Removal and Installation".
5.CHECK INTERMITTENT INCIDENT
Refer to GI "Intermittent Incident".
>> Inspection End.
Component Inspection
1.CHECK MAIN POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH
- Turn ignition switch OFF.
- Disconnect main power window and door lock/unlock switch connector.
- Check continuity between main power window and door lock/unlock switch terminals.

Is the inspection result normal?
YES >> Inspection End
NO >> Replace main power window and door lock/unlock switch. Refer to PWC "Removal and Installation".