Stall test
In this manual: Stall test
9steps
~54min
2/5difficulty
Done 0 of 9
Work Procedure
INSPECTION
- Inspect the amount of engine oil. Replenish the engine oil if necessary. Refer to LU "Inspection".
- Drive for about 10 minutes to warm up the vehicle so that the A/T fluid temperature is 50 to 80C (122 to 176F).
- Inspect the amount of ATF. Replenish if necessary. Refer to TM, "Inspection".
- Securely engage the parking brake so that the tires do not turn.
- Start the engine, apply foot brake, and place selector lever in "D" position.
- Gradually press down the accelerator pedal while holding down the foot brake.
- Quickly read off the stall speed, then quickly release the accelerator pedal.
CAUTION: Never hold down the accelerator pedal for more than 5 seconds during this test.
Stall speed : Refer to TM, "Stall Speed".
- Shift the selector lever to "N" position.
- Cool down the ATF.
CAUTION: Run the engine at idle for at least 1 minute.
10. Repeat steps 6 through 9 with selector lever in "1", "2" and "R" positions.
JUDGMENT OF STALL TEST 
O: Stall speed within standard value position
H: Stall speed higher than standard value
L: Stall speed lower than standard value
Was this page helpful?