Drive belt idler pulley
In this manual: Drive belt idler pulley
5steps
~30min
2/5difficulty
Done 0 of 5
Exploded View

1. Generator bracket 2. Center shaft 3. Spacer 4. Adjusting bolt 5. Washer 6. Idler pulley 7. Plate
Removal and Installation
REMOVAL
- Remove the fender protector (RH).
- Remove the air duct inlet assembly.
- Remove drive belt.
- Remove the lock nut, and then remove the plate, idler pulley, and washer.
- Remove the center shaft together with the spacer and the adjusting bolt.
INSTALLATION
- Insert the center shaft (1) into the slide groove of the spacer (2).Fully screw in the adjusting bolt (3) in the belt loosening direction (
).
- At that time, place the flange (a) of the adjusting bolt and the seat (b) of the center shaft on the spacer.
- Place each surface (c and d) of the spacer on the generator bracket. Install the washer, idler pulley, and plate, and then temporarily tighten the lock nut.
Lock nut (Temporary tightening) : 4.4 N*m (0.45 kgm, 39 inlb)

- Installation is in the reverse order of removal.
Was this page helpful?