Rear spoiler
In this manual: Rear spoiler
~1min read
Exploded View

1. Rear spoiler 2. High-mounted stop lamp harness connector 3. Harness grommet
Removal and Installation
Removal
1. Remove trunk lid finisher (if equipped). Refer to EXT "Removal and Installation".
2. Disconnect high-mounted stop lamp harness connector (1).
3. Remove the rear spoiler nuts.

4. Using a suitable heating tool may also be necessary to evenly heat the rear spoiler contact surface while releasing the tape with a suitable tool.
5. Loosen the harness grommet and gently lift the rear spoiler upward off of trunk lid.
Installation
Installation is in the reverse order of removal.
NOTE:
- Before installing rear spoiler, clean the surface where it will be mounted with isopropyl alcohol or equivalent to degrease the surface.
- Before installing, be sure there are no gaps or waves in the adhesive-backed foam tape where the surfaces meet.
- During installation, be sure harness grommet of high-mounted stop lamp is fully seated into trunk lid opening prior to final rear spoiler placement.
Was this page helpful?