C1155 BR Fluid level low
DTC Logic
DTC DETECTION LOGIC 
DTC CONFIRMATION PROCEDURE
1.CHECK SELF-DIAGNOSIS RESULTS
Check the self-diagnosis results. ![]()
Is above displayed on the self-diagnosis display?
YES >> Proceed to diagnosis procedure. Refer to BRC "Diagnosis Procedure".
NO >> Inspection End.
Diagnosis Procedure
Regarding Wiring Diagram information, refer to BRC "Wiring Diagram".
NOTE: Check brake fluid level in brake reservoir tank before starting inspection.
1.CONNECTOR INSPECTION
- Turn ignition switch OFF.
- Disconnect combination meter and brake fluid level switch connectors.
- Check connectors and terminals for deformation, disconnection, looseness or damage.
Is the inspection result normal?
YES >> GO TO 2
NO >> Repair or replace as necessary.
2.CHECK BRAKE FLUID LEVEL SWITCH
Perform the brake fluid level switch component inspection. Refer to BRC"Component Inspection".
Is the inspection result normal?
YES >> GO TO 3
NO >> Replace brake fluid level switch. Refer to BR "Exploded View".
3.CHECK BRAKE FLUID LEVEL SWITCH HARNESS
- Check continuity between combination meter connector and brake fluid level switch connector E40 terminal 1.

2. Check continuity between combination meter connector and ground. 
Is the inspection result normal?
YES >> GO TO 4
NO >> Repair or replace malfunctioning components.
4.CHECK BRAKE FLUID LEVEL SWITCH GROUND CIRCUIT
Check continuity between brake fluid level switch connector E40 terminal 2 and ground. 
Is the inspection result normal?
YES >> Replace ABS actuator and electric unit (control unit). Refer to BRC "Removal and Installation"
NO >> Repair or replace malfunctioning components.
Component Inspection
1.CHECK BRAKE FLUID LEVEL SWITCH
- Turn ignition switch OFF.
- Disconnect brake fluid level switch connector.
- Check continuity between brake fluid level switch terminals 1 and 2.


Is the inspection result normal?
YES >> Inspection End.
NO >> Replace brake fluid level switch. Refer to BR "Exploded View".