Front wheel hub and knuckle
In this manual: Front wheel hub and knuckle
~1min read
Inspection
- Check the axle and suspension parts for excessive play, wear, or damage.
- Shake each front wheel to check for excessive play as shown.

FRONT WHEEL BEARING INSPECTION
- Move wheel hub and bearing assembly in the axial direction by hand. Make sure the axial end play is within specification.
Axial end play : Refer to FAX "Wheel Bearing".
- Check that the wheel hub bearing operates smoothly.
- Replace the wheel hub assembly if the axial end play exceeds specification, or if the wheel bearing does not turn smoothly. Refer to FAX "Removal and Installation".
CAUTION: The wheel hub assembly does not require maintenance. If any of the following symptoms are noted, replace the wheel hub assembly.
- Growling noise is emitted from the wheel hub bearing during operation.
- Wheel hub bearing drags or turns roughly.
FRONT DRIVE SHAFT
Inspection
- Check drive shaft mounting point and joint for looseness and other damage.
- Check boot for cracks and other damage. Replace or repair components as necessary. Refer to FAX "Removal and Installation", FAX "Disassembly and Assembly".
CAUTION: Replace entire drive shaft assembly when noise or vibration occur from drive shaft.
REMOVAL AND INSTALLATION
Was this page helpful?