Rear suspension beam
In this manual: Rear suspension beam
10steps
~60min
3/5difficulty
Done 0 of 10
Exploded View

1. Rear suspension beam
Removal and Installation
REMOVAL
- Remove the wheel and tire assemblies using power tool. Refer to WT "Adjustment".
- Remove wheel sensor and sensor harness. Refer to BRC "REAR WHEEL SENSOR : Removal and Installation".
- Remove brake hose and brake pipe from rear suspension beam. Refer to BR "REAR : Removal and Installation".
- Remove the rear drum brake assemblies. Refer to BR "Removal and Installation".
- Remove parking brake cable from rear suspension beam. Refer to PB"Removal and Installation".
- Position a suitable jack under rear suspension beam.
CAUTION:
- Place the jack in the center of the suspension beam.
- Do not damage the suspension beam with jack.
- Remove shock absorber bolts (lower side). Refer to RSU "Removal and Installation".
- Remove coil spring. Refer to RSU "Removal and Installation".
- Remove rear suspension beam bolts and nuts.
- Slowly lower jack, remove rear suspension beam from vehicle body.
CAUTION: While lowering the rear suspension beam with the jack, be sure to maintain the stability of the jack.
INSTALLATION
Installation is in the reverse order of removal.
- Perform final tightening of rear suspension beam installation position (rubber bushing), under unladen conditions with tires on level ground.
- Check wheel sensor harness for proper connection. Refer to BRC "REAR WHEEL SENSOR : Exploded View".
- Adjust parking brake. Refer to PB "Inspection and Adjustment".
- Check wheel alignment. Refer to RSU "Inspection".
SERVICE DATA AND SPECIFICATIONS (SDS)
Wheel Alignment

Measure value under unladen* conditions.
*: Fuel, engine coolant and lubricant are full. Spare tire, jack, hand tools and mats are in designated positions.
Wheelarch Height

Measure value under unladen* conditions.
*: Fuel, engine coolant and lubricant are full. Spare tire, jack, hand tools and mats are in designated positions.
Was this page helpful?