Hood lock control cable
In this manual: Hood lock control cable
5steps
~30min
2/5difficulty
Done 0 of 5
HOOD LOCK CONTROL CABLE : Removal and Installation
REMOVAL
- Disconnect hood lock control cable assembly from hood lock assembly. Refer to DLK "HOOD LOCK : Removal and Installation".
- Remove fender protector (LH). Refer to EXT "Removal and Installation".
- Release hood lock control cable clips.
- Remove hood lock/fuel filler door release handle assembly bolts (A).
- Disconnect hood lock control cable assembly from hood lock/ fuel filler door release handle assembly.

6. Remove dash side finisher (LH). Refer to INT "DASH SIDE FINISHER : Removal and Installation"
7. Remove grommet on the lower dash and pull the hood lock control cable into the passenger compartment.
CAUTION: While pulling, be careful not to damage (peel) the outside of the hood lock control cable.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
- Be careful not to bend cable too much, keep the radius 100 mm (3.94 in) or more.
- Check that cable is not offset from the positioning grommet, and apply the sealant to the grommet (at * mark).
- Check that hood lock control cable is properly engaged with hood lock.
- After installation, perform hood adjustment procedure. Refer to DLK "HOOD ASSEMBLY : Adjustment".
- After installation, perform hood lock inspection. Refer to DLK "Inspection".

Was this page helpful?