Door lock
In this manual: Door lock
~1min read
DOOR LOCK : Removal and Installation
REMOVAL
1. Remove inside handle. Refer to DLK "INSIDE HANDLE : Removal and Installation".
2. Remove outside handle. Refer to DLK "OUTSIDE HANDLE : Removal and Installation".
3. Remove bolt (A) from the front door glass channel rear (1).

4. Disconnect the harness connector from door lock actuator.
5. Remove door lock assembly bolts and door lock assembly.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
- Do not reuse door lock assembly bolt. Always replace it with a new one when it is removed.
- After installation, check door open/close, lock/unlock operation.
- Check door lock cable is properly engaged with outside handle bracket.
- Check door lock assembly for poor lubrication. Apply a suitable multi-purpose grease to door lock if necessary.

Was this page helpful?