Power supply routing circuit
In this manual: Power supply routing circuit
~1min read
Wiring Diagram - Battery Power Supply -








Wiring Diagram - Accessory Power Supply -




Wiring Diagram - Ignition Power Supply -








Fuse
- If fuse is blown, be sure to eliminate cause of malfunction before installing new fuse.
- Use fuse of specified rating. Never use fuse of more than specified rating.
- Do not partially install fuse; always insert it into fuse holder properly.
- Remove fuse for "ELECTRICAL PARTS (BAT)" if vehicle is not used for a long period of time.

Fusible Link
A melted fusible link can be detected either by visual inspection or by feeling with finger tip. If its condition is questionable, use circuit tester or test lamp.
1 : Fusible link
Vehicle front

CAUTION:
- If fusible link should melt, it is possible that critical circuit (power supply or large current carrying circuit) is shorted. In such a case, carefully check and eliminate cause of malfunction.
- Never wrap outside of fusible link with vinyl tape. Important: Never let fusible link touch any other wiring harness, vinyl or rubber parts.
GROUND
Ground Distribution
MAIN HARNESS



ENGINE ROOM HARNESS


ENGINE CONTROL HARNESS

BODY HARNESS

Was this page helpful?