Calibration of G Sensor
In this manual: Calibration of G Sensor
8steps
~48min
2/5difficulty
Done 0 of 8
Description
TCM stores calibration data (inherent characteristic value) of G sensor to provide accurate control. Therefore, it is required to perform calibration of G sensor after the following work is performed.
- Removal/installation or replacement of G sensor
- Replacement of TCM
Work Procedure
1.PREPARATION BEFORE CALIBRATION PROCEDURE
- Park the vehicle on a level surface.
- Adjust air pressure of all tires to the specified pressure. WT "Tire Air Pressure".
>> GO TO 2.
2.PERFORM CALIBRATION
With CONSULT
- Turn ignition switch ON.
CAUTION: Never start engine.
- Select "Work Support" in "TRANSMISSION".
- Select "G SENSOR CALIBRATION".
- Touch "Start".
CAUTION: Never swing the vehicle during "G sensor calibration".
Is "COMPLETED" displayed?
YES >> GO TO 3.
NO >> Perform steps 1 and 2 again.
3.PERFORM THE SELF-DIAGNOSIS
With CONSULT
- Turn ignition switch OFF and wait for 10 seconds.
- Turn ignition switch ON.
- Select "Self Diagnostic Results" in "TRANSMISSION".
Is "P1586" or "P1588" detected?
YES >> Go to TM "DTC Index".
NO >> Calibration end
Was this page helpful?