Output speed sensor
In this manual: Output speed sensor
3steps
~18min
2/5difficulty
Done 0 of 3
Exploded View

1. Transaxle assembly 2. Output speed sensor 3. O-ring
Front
Genuine NISSAN CVT Fluid NS-3
Removal and Installation
REMOVAL
- Disconnect the harness connector from output speed sensor.
NOTE: Lift up the vehicle and perform the work from rear of the transaxle assembly.
- Remove the output speed sensor.
- Remove the O-ring from the output speed sensor.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
- Do not reuse O-ring.
- Apply Genuine NISSAN CVT Fluid NS-3 to the O-ring.
Inspection and Adjustment
INSPECTION AFTER INSTALLATION
Check for CVT fluid leakage. Refer to TM "Inspection".
ADJUSTMENT AFTER INSTALLATION
Check the CVT fluid level. Refer to TM "Adjustment".
Was this page helpful?