U1117 Lost communication (ABS)
In this manual: U1117 Lost communication (ABS)
2steps
~12min
1/5difficulty
Done 0 of 2
DTC Logic
DTC DETECTION LOGIC
| DTC | Trouble diagnosis name | DTC detection condition | Possible causes |
| U1117 | Lost Communication With ABS | When the ignition switch is ON, TCM is unable to receive the CAN communications signal from ABS actuator control unit continuously for 2 seconds or more. |
|
DTC CONFIRMATION PROCEDURE
1.PREPARATION BEFORE WORK
If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn the ignition switch OFF and wait for at least 10 seconds, then perform the next test.
>> GO TO 2.
2.PERFORM DTC CONFIRMATION PROCEDURE
- Turn ignition switch ON, and wait for 5 seconds or more.
- Check the DTC.
Is "U1117" detected?
YES >> Go to TM, "Diagnosis Procedure".
NO >> INSPECTION END
Diagnosis Procedure
For the diagnosis procedure, refer to LAN, "Trouble Diagnosis Flow Chart".
Was this page helpful?