P072F Stuck in 4GR
DTC Logic
DTC DETECTION LOGIC
| DTC | Trouble diagnosis name | DTC detection condition | Possible causes |
| P072F | Stuck in Gear 4 | The following diagnosis conditions are met and the detection conditions continue for 0.5 seconds or more. - Diagnosis condition - Shifting is not in progress. - Stop lamp switch OFF - Detection conditions - Deceleration: Less than − 0.35 G - Gear ratio: 6% or more, or − 6% or less compared with normal gear ratio |
- Low clutch solenoid valve - Control valve assembly |
DTC REPRODUCTION PROCEDURE
CAUTION:
- "TM, "Diagnosis Procedure"" must be performed before starting "DTC CONFIRMATION PROCEDURE".
- Never perform "DTC CONFIRMATION PROCEDURE" before completing the repair, which may cause secondary malfunction.
- Always drive vehicle at a safe speed.
1.PREPARATION BEFORE WORK
If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn the ignition switch OFF and wait for at least 10 seconds, then perform the next test.
>> GO TO 2.
2.CHECK DTC DETECTION
- Start the engine.
- Drive the vehicle.
- Maintain the following conditions for 5 seconds or more.
- Check the first trip DTC.
Selector lever : D position
Gear : 4GR
Stop lamp switch : OFF
Vehicle speed : 20 km/h or more
Is "P072F" detected?
YES >> Go to TM, "Diagnosis Procedure".
NO >> INSPECTION END
Diagnosis Procedure
1.MALFUNCTION CAUSE SIMULATION TEST
Refer to GI, "Intermittent Incident".
Is the check result normal?
YES >> Replace the transaxle assembly. Refer to TM, "Removal and Installation".
NO >> Repair or replace the malfunctioning parts.