Trunk lid opener actuator
In this manual: Trunk lid opener actuator
9steps
~54min
2/5difficulty
Done 0 of 9
Component Function Check
1.CHECK FUNCTION
- Select INTELLIGENT KEY of BCM using CONSULT.
- Select TRUNK/GLASS HATCH in ACTIVE TEST mode.
- Touch OPEN to check that it works normally.
Is the inspection result normal?
YES >> Trunk lid opener actuator is OK.
NO >> Refer to DLK "Diagnosis Procedure".
Diagnosis Procedure
Regarding Wiring Diagram information, refer to DLK "TRUNK LID OPENER SYSTEM : Wiring Diagram".
1.CHECK TRUNK LID OPENER INPUT SIGNAL
- Turn ignition switch OFF.
- Disconnect trunk lid lock assembly connector.
- Check voltage between trunk lid lock assembly harness connector and ground.

Is the inspection result normal?
YES >> GO TO 3.
NO >> GO TO 2.
2.CHECK TRUNK LID OPENER ACTUATOR CIRCUIT
- Disconnect BCM connector.
- Check continuity between BCM harness connector and trunk lid lock assembly harness connector.

- Check continuity between BCM harness connector and ground.

Is the inspection result normal?
YES >> Replace BCM. Refer to BCS "Removal and Installation".
NO >> Repair or replace harness.
3.CHECK TRUNK LID OPENER ACTUATOR GROUND CIRCUIT
Check continuity between trunk lid lock assembly harness connector and ground. 
Is the inspection normal?
YES >> Replace trunk lid lock assembly.
NO >> Repair or replace harness.
Was this page helpful?