Keyfob battery
Removal and Installation
REPLACEMENT
1. Remove screw from the rear of keyfob.
2. Place the key with the lower case facing up. Use a suitable tool wrapped with tape between upper case and lower case and separate the lower case from the upper case.
CAUTION:
- Do not touch the circuit board or battery terminal. Doing so could cause the keyfob to malfunction
- The keyfob is water-resistant. However, if it does get wet, immediately wipe it dry.
3. When replacing the circuit board assembly, remove circuit board assembly from the upper case.
[Circuit board assembly: Switch rubber + Board surface]
CAUTION: Do not touch the printed circuits directly.
4. Remove the battery from the lower case and replace it.
Battery replacement : Coin-type lithium battery (CR1620)
CAUTION: When replacing battery, keep dirt, grease, and other foreign materials off the electrode contact area.
5. After replacement, fit the lower and upper cases together and tighten with the screw.
CAUTION: After replacing the battery, Be sure to check that door locking operates normally using the keyfob.
Refer to DLK "Component Function Check".