Inspection and adjustment
Additional service when replacing control unit
ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Description
Always perform zero point reset using CONSULT when removing and installing the passenger seat or servicing the occupant classification system.
ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Requirement
WORK PROCEDURE WHEN REPLACING OCS CONTROL UNIT
1.PERFORM ZERO POINT RESET
Perform zero point reset. Refer to SRC "ZERO POINT RESET : Special Repair Requirement".
>> END
Zero point reset
ZERO POINT RESET : Description
Zero point reset is an initializing procedure for the OCS (weight) sensors that must be performed using CONSULT when removing and installing passenger seat or servicing the OCS system. If zero point reset is not performed, the initialization is incomplete and OCS may not operate normally.
NOTE:
- When reinstalling the passenger seat, the initial value for the OCS sensors may change, and the OCS may not operate normally.
- When zero point reset is performed after removal and installation of passenger seat, CONSULT displays ""complete"".
ZERO POINT RESET : Special Repair Requirement
1.PERFORM ZERO POINT RESET
1. Perform preliminary checks:
NOTE:
- Level the vehicle
- Minimize vibrations near the vehicle
- Remove any objects on passenger seat
- Do not touch the vehicle during zero point reset
- Select START on ZERO POINT RESET from, WORK SUPPORT of "OCCUPANT DETECTION".
- "Zero point reset" starts.
>> GO TO 2.
2.CONFIRM RESET
1. Check that ""Complete" is displayed on "Zero point reset status".
CAUTION:
- "Complete" may be displayed if the seat has been reinstalled, or "zero point reset" has already been performed.
- "Incomplete" may be displayed if a new seat is installed.
- Air bag warning lamp blinks in user mode if zero point reset is "incomplete".
Is zero point reset status "complete"?
YES >> Print out "ZERO POINT RESET CURRENT STATUS" screen. Inspection end.
NO >> Recheck the preliminary check items and perform zero point reset again.
INTERMITTENT INCIDENT
Inspection Procedure
INTERMITTENT TROUBLE
An intermittent incident may have occurred in the past but is not being detected currently. This DTC will not be detected on SELF-DIAG [CURRENT], but may be viewed on SELF-DIAG [PAST] if the DTC has not been erased.
Trouble Diagnosis with CONSULT
CHECK SRS REPAIR HISTORY
Refer to SRC "SRS History Check".