Line pressure test
In this manual: Line pressure test
8steps
~48min
2/5difficulty
Done 0 of 8
Work Procedure
INSPECTION
- Inspect the amount of engine oil. Replenish the engine oil if necessary. Refer to LU, "Inspection".
- Drive for about 10 minutes to warm up the vehicle so that the A/T fluid temperature is to 50 to 80C (122 to 176F).
- Inspect the amount of ATF. Replenish if necessary. Refer to TM, "Inspection".
- Remove fluid pressure detection plug.
- Install the joint pipe adapter [SST: KV31103600 ( - )], adapter [SST: 25054000 (J-25695-4)], and oil pressure gauge set (commercial service tool).
NOTE: When using oil pressure gauge, be sure to use O-ring attached to fluid pressure detection plug.
- Securely engage parking brake so that the tires do not turn.
- Start the engine.
- Measure the line pressure at both idle and the stall speed.
CAUTION: Keep brake pedal pressed all the way down during measurement.
1 : "D" position fluid pressure detection plug
2 : "R" position fluid pressure detection plug

Line pressure : TM, "Line Pressure"
9. Install O-rig to fluid pressure detection plug.
CAUTION:
- Do not reuse O-ring.
- Apply ATF to O-ring.
10. Install fluid pressure detection plug.
: 7.4 N*m (1.70 lb-m, 66 in-lb)
JUDGMENT

DTC/Circuit diagnosis
Was this page helpful?