Gear oil
In this manual: Gear oil
12steps
~72min
3/5difficulty
Done 0 of 12
Inspection
OIL LEAKAGE
Make sure that gear oil is not leaking from transaxle or around it.
OIL LEVEL
- Remove filler plug (1) and gasket from transaxle case.
- Check the oil level from filler plug hole as shown. CAUTION: Do not start engine while checking oil level.
- Install a new gasket on filler plug and then install filler plug to transaxle case. CAUTION: Do not reuse gasket.
- Tighten filler plug to the specified torque. Refer to TM, "Exploded View".

Draining
- Start engine and let it run to warm up transaxle.
- Stop engine. Remove drain plug (1) and gasket, using suitable tool and then drain gear oil.
- Install a new gasket on drain plug (1) and install drain plug to clutch housing, using suitable tool.
CAUTION: Do not reuse gasket.
- Tighten drain plug (1) to the specified torque. Refer to TM, "Exploded View".

Refilling
- Remove filler plug (1) and gasket from transaxle case.
- Fill with new gear oil until oil level reaches the specified limit at filler plug hole as shown.
CAUTION: Do not start engine while checking oil level.
Oil capacity and viscosity : Refer to MA, "Fluids and Lubricants".
- Install a new gasket on filler plug and then install filler plug to transaxle case.
CAUTION: Do not reuse gasket.
- Tighten filler plug to the specified torque. Refer to TM, "Exploded View".

Was this page helpful?