Trunk lid opener switch
Component Function Check
1.CHECK FUNCTION
- Select TRUNK of BCM using CONSULT.
- Select TR/BD OPEN SW in DATA MONITOR mode.
- Check that the function operates normally according to the following conditions.

Is the inspection result normal?
YES >> Trunk lid switch is OK.
NO >> Refer to DLK "Diagnosis Procedure".
Diagnosis Procedure
Regarding Wiring Diagram information, refer to DLK "TRUNK LID OPENER SYSTEM : Wiring Diagram".
1.CHECK TRUNK LID OPENER INPUT SIGNAL
- Turn ignition switch OFF.
- Disconnect trunk lid switch connector.
- Check signal between trunk lid switch harness connector and ground using oscilloscope.

Is the inspection result normal?
YES >> GO TO 3.
NO >> GO TO 2.
2.CHECK TRUNK LID OPENER SWITCH CIRCUIT
- Disconnect BCM connector.
- Check continuity between BCM harness connector and trunk lid switch harness connector.

- Check continuity between BCM harness connector and ground.

Is the inspection result normal?
YES >> Replace BCM. Refer to BCS "Removal and Installation".
NO >> Repair or replace harness.
3.CHECK TRUNK LID SWITCH GROUND CIRCUIT
Check continuity between trunk lid switch harness connector and ground. 
Is the inspection result normal?
YES >> GO TO 4.
NO >> Repair or replace harness.
4.CHECK TRUNK LID SWITCH
Refer to DLK "Component Function Check".
Is the inspection result normal?
YES >> GO TO 5.
NO >> Replace trunk lid switch.
5.CHECK INTERMITTENT INCIDENT
Refer to GI "Intermittent Incident".
>> Inspection End.
Component Inspection
1.CHECK TRUNK LID SWITCH
- Turn ignition switch OFF.
- Disconnect trunk lid switch connector.
- Check continuity between trunk lid switch terminals.

Is the inspection result normal?
YES >> Inspection End.
NO >> Replace trunk lid switch.