Position switch
In this manual: Position switch
4steps
~24min
2/5difficulty
Done 0 of 4
Back-up lamp switch
BACK-UP LAMP SWITCH : Component Inspection
1.CHECK BACK-UP LAMP SWITCH
- Disconnect position switch connector. Refer to TM, "Removal and Installation".
- Check continuity between position switch terminals.

Is the inspection result normal?
YES >> INSPECTION END
NO >> Replace position switch. Refer to TM, "Removal and Installation".

Park/neutral position (pnp) switch
PARK/NEUTRAL POSITION (PNP) SWITCH : Component Inspection
1.CHECK PARK/NEUTRAL POSITION (PNP) SWITCH
- Disconnect position switch connector. Refer to TM, "Removal and Installation".
- Check continuity between position switch terminals.

Is the inspection result normal?
YES >> INSPECTION END
NO >> Replace position switch. Refer to TM, "Removal and Installation".

NOISE, VIBRATION AND HARSHNESS (NVH) TROUBLESHOOTING
NVH Troubleshooting Chart
Use the chart below to find the cause of the symptom. The numbers indicate the order of the inspection. If necessary, repair or replace these parts.

Was this page helpful?