Stall test
In this manual: Stall test
9steps
~54min
2/5difficulty
Done 0 of 9
Work Procedure
INSPECTION
- Check the engine oil level. Replenish if necessary.
- Check for leak of the CVT fluid. Refer to TM "Inspection".
- Drive for about 10 minutes to warm up the vehicle so that the CVT fluid temperature is 50 to 80C (122 to 176F).
- Be sure to apply the parking brake and block the tires.
- Start the engine, depress the brake pedal and put the selector lever to the D position.
- While depressing the brake pedal, depress the accelerator pedal gradually.
- Read the stall speed quickly. Then, release your foot from the accelerator pedal quickly.
CAUTION: Do not depress the accelerator pedal for 5 seconds or more during the test.
Stall speed : Refer to TM "Stall Speed".
- Place the selector lever in the N position.
- Cool the CVT fluid.
CAUTION: Run the engine with the idle speed for at least 1 minute.
- Put the selector lever to the R position and perform Step 6 to Step 9 again.
NARROWING-DOWN MALFUNCTIONING PARTS 
O: Within the stall speed standard value
H: Stall speed is higher than the standard value.
L: Stall speed is lower than the standard value.
Was this page helpful?