Door lock
In this manual: Door lock
5steps
~30min
2/5difficulty
Done 0 of 5
DOOR LOCK : Removal and Installation
REMOVAL
- Remove inside handle. Refer to DLK "INSIDE HANDLE : Removal and Installation".
- Remove outside handle. Refer to DLK "OUTSIDE HANDLE : Removal and Installation".
- Disconnect the harness connector from door lock actuator (if equipped).
- Remove front door lower sash (rear). Refer to GW "Exploded View".
- Remove door lock assembly bolts and door lock assembly.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
- Do not reuse door lock assembly bolt. Always replace it with a new one when it is removed.
- After installation, check door open/close, lock/unlock operation.
- Check door lock cable is properly engaged with outside handle bracket.
- Check door lock assembly for poor lubrication. Apply a suitable multi-purpose grease to door lock if necessary.

Was this page helpful?