Rear door finisher
Exploded View

1. Rear door panel 2. Rear door finisher 3. Rear power window switch finisher (if equipped) 4. Grommet
Clip
Metal clip
Pawl
Removal and Installation
REMOVAL
- Fully open rear door window.
- Remove rear door finisher clip (A).

- Remove rear power window switch and finisher as an assembly (if equipped). Refer to PWC "Removal and Installation".
- Remove rear door finisher.
a. Remove rear door finisher bolt (A).

b. Release rear door finisher clips and metal clips using a suitable tool (A) and remove rear door finisher as shown.
: Clip
: Metal clip
CAUTION: Apply protective tape (B) on the door panel and/or door finisher to protect from damage.

INSTALLATION
Installation is in the reverse order of removal.
CAUTION: When installing rear door finisher, make sure the clips and metal clips are securely pressed into door panel holes.
BODY SIDE TRIM
Exploded View

1. Rear body side welt 2. Center pillar upper finisher 3. Front body side welt 4. Front pillar finisher 5. Dash side finisher 6. Front kicking plate 7. Center pillar lower finisher 8. Rear kicking plate 9. Rear pillar finisher
Clip
Pawl
Metal clip