Fluid cooler tube
In this manual: Fluid cooler tube
4steps
~24min
2/5difficulty
Done 0 of 4
Exploded View

1. Fluid cooler tube A 2. Copper sealing washer 3. Fluid cooler tube B 4. Bolt 5. Transaxle assembly
Removal and Installation
WARNING:
- Do not open the radiator cap or drain plug when the engine is hot. There is a danger that hot liquid may spray out, causing serious injury.
- Perform these steps after the coolant temperature has cooled sufficiently.
CAUTION: Do not reuse copper sealing washers.
NOTE: Lift up the vehicle and perform the work from below.
REMOVAL
- Remove fluid cooler hose and fluid cooler tube A.
- Disconnect the washer from fluid cooler tube A.
- Remove fluid cooler hose and fluid cooler tube B.
- Disconnect the washer from fluid cooler tube B.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION: Do not reuse copper sealing washers.
When installing the fluid cooler tube A (1) and B (2) onto the transaxle assembly, install it so that it is in contact with the transaxle case rib (A).

Inspection and Adjustment
INSPECTION AFTER INSTALLATION
Check for A/T fluid leakage. Refer to TM "Inspection".
ADJUSTMENT AFTER INSTALLATION
Check the A/T fluid level. Refer to TM "Adjustment".
Fluid cooler hose
Exploded View
Removal and Installation
Inspection and Adjustment
INSPECTION AFTER INSTALLATION
Check for A/T fluid leakage. Refer to TM "Inspection".
ADJUSTMENT AFTER INSTALLATION
Adjust the A/T fluid level. Refer to TM "Adjustment".
Was this page helpful?