Valve oil seal
In this manual: Valve oil seal
7steps
~42min
2/5difficulty
Done 0 of 7
VALVE OIL SEAL : Removal and Installation
REMOVAL
- Remove camshafts.
- Remove valve lifters.
- Rotate crankshaft, and set piston with valve oil seal to be removed to TDC. This will prevent the valve from dropping into cylinder.
CAUTION:
When rotating crankshaft, be careful to avoid scarring front cover with timing chain.
4. Remove valve collet.
- Compress valve spring with Tool (A). Remove valve collet with a magnet hand (B).
CAUTION:
Be careful not to damage valve lifter holes.
Tool number : KV10116200 (J26336B)
: KV10115900 (J2633620)
: KV10109220 ( - )

- Remove valve spring retainer, valve spring and valve spring seat.
- Remove valve oil seal with Tool (A).
Tool number : KV10107902 (J38959)

INSTALLATION
- Apply new engine oil to valve oil seal joint surface and seal lip.
- Press in valve oil seal to the height "H" shown with Tool (A).
Height "H" : 13.2 13.8 mm (0.520 0.543 in)
Tool number : KV10115600 (J38958)

3. Installation of the remaining components is in the reverse order of removal.
Was this page helpful?