Front fog lamp
Exploded View

1. Front fog lamp bulb 2. Front fog lamp 3. Front bumper fascia 4. Front fog lamp finisher
Removal and Installation
REMOVAL
1. Remove the fender protector. Refer to EXT "Removal and Installation".
2. Disconnect the harness connector from the front fog lamp.
3. Remove the screws and front fog lamp.
INSTALLATION
Installation is in the reverse order of removal.
NOTE: After installation, perform fog lamp aiming adjustment procedure. Refer to EXL "Aiming Adjustment Procedure".
Bulb Replacement
WARNING: Do not touch bulb with your hand while it is on or right after being turned off. Burning may result.
CAUTION:
- Disconnect the battery negative terminal or remove power circuit fuse while performing the operation.
- Do not touch the glass surface of the bulb with bare hands or allow oil or grease to get on it to prevent damage to the bulb.
- Do not leave bulb out of lamp reflector for a long time because dust, moisture smoke, etc. may affect the performance of lamp. When replacing bulb, be sure to replace it with new one.
FRONT FOG LAMP BULB
Removal
1. Remove the fender protector. Refer to EXT "Removal and Installation".
2. Disconnect the harness connector (1) from front fog lamp bulb.
3. Rotate the bulb (2) counterclockwise and remove.

Installation
Installation is in the reverse order of removal.