Precautions
In this manual: Precautions
~1min read
Precautions for Trouble Diagnosis
CAUTION: Follow the instructions listed below. Failure to do this may cause damage to parts:
- Never apply 7.0 V or more to the measurement terminal.
- Use a tester with open terminal voltage of 7.0 V or less.
- Turn the ignition switch OFF and disconnect the battery cable from the negative terminal when checking the harness.
Precautions for Harness Repair
- Solder the repaired area and wrap tape around the soldered area.
NOTE: A fray of twisted lines must be within 110 mm (4.33 in).

- Bypass connection is never allowed at the repaired area.
NOTE: Bypass connection may cause CAN communication error. The spliced wire becomes separated and the characteristics of twisted line are lost.

- Replace the applicable harness as an assembly if error is detected on the shield lines of CAN communication line.
SYSTEM DESCRIPTION
Was this page helpful?