Parking brake control
In this manual: Parking brake control
12steps
~72min
3/5difficulty
Done 0 of 12
Exploded View

1. Parking brake lever assembly 2. Adjusting nut 3. Parking brake switch 4. Front cable 5. Rear cable (LH) 6. Rear cable (RH)
Removal and Installation
REMOVAL
- Remove rear wheel and tire assemblies using power tool. Refer to WT "Adjustment".
- Remove the center console assembly. Refer to IP "Removal and Installation".
- Disconnect the harness connector from the parking brake switch.
- Remove and discard the adjusting nut to loosen the front cable.
CAUTION: Do not reuse the adjusting nut.
- Separate both rear cables from the front cable.
- Remove the parking brake lever assembly and front cable.
- Remove the front cable from parking brake lever assembly.
- Remove the parking brake switch from parking brake lever assembly.
- Remove both rear cables from the toggle lever.
- Remove the center floor insulator to gain access to the rear cable bolts.
- Remove the brake shoes and disconnect the rear cables from the toggle levers. Refer to BR "Removal and Installation".
- Disconnect and remove the rear cables from each backing plate.
INSTALLATION
Installation is in the reverse order of the removal.
CAUTION: Do not reuse the adjusting nut.
- Perform adjustment after installation. Refer to PB "Inspection and Adjustment".
SERVICE DATA AND SPECIFICATIONS (SDS)
Parking Brake Control 
Was this page helpful?