Front regulator
Exploded View

1. Front door panel 2. Front door lower sash (front) 3. Front door glass run 4. Front door sealing screen 5. Front door power window motor 6. Front door regulator 7. Front door glass 8. Front door lower sash (rear) 9. Regulator seal (manual window) 10. Snap pin (manual window) 11. Regulator handle (manual window)
Removal and Installation
REMOVAL
1. Remove front door glass. Refer to GW "Removal and Installation".
2. Disconnect the harness connector from front door power window motor.
3. Remove front door regulator assembly bolts and nuts.
4. Remove front door regulator assembly from front door panel.
INSTALLATION
Installation is in the reverse order of removal.
Disassembly and Assembly
DISASSEMBLY
Remove the power window motor from the regulator assembly.
INSPECTION AFTER REMOVAL
Check the regulator assembly for the following items. Replace or grease it if a malfunction is detected.
- Wire wear
- Regulator deformation
- The arrows shows the application points of the multi-purpose grease.

ASSEMBLY
Assembly is in the reverse order of disassembly.
Inspection and Adjustment
FITTING INSPECTION
- Check that the glass fits securely into the sash groove.
- Lower the glass slightly [approximately 10 to 20 mm (0.394 to 0.787 in)], and check that the clearance to the sash is parallel. Loosen the regulator bolts, guide rail bolts, and glass and guide rail bolts to correct the glass position if the clearance between the glass and sash is not parallel.