Position switch
In this manual: Position switch
6steps
~36min
2/5difficulty
Done 0 of 6
Removal and Installation
REMOVAL
- Drain gear oil. Refer to TM, "Draining".
- Disconnect the harness connector (A) from position switch.
- Remove position switch from transaxle case.

INSTALLATION
- Apply recommended sealant to threads of position switch.
CAUTION:
- Use Genuine Silicone RTV or equivalent. Refer to GI, "Recommended Chemical Products and Sealants".
- Remove old sealant and oil adhering to threads.
- Install position switch to transaxle case.
- Tighten position switch to the specified torque. Refer to TM, "Exploded View".
- Refill gear oil. Refer to TM, "Refilling".
Inspection
INSPECTION AFTER INSTALLATION
- Check continuity between position switch terminals. Refer to TM, "BACK-UP LAMP SWITCH : Component Inspection" (Back-up lamp switch) and TM, "PARK/NEUTRAL POSITION (PNP) SWITCH : Component Inspection" (PNP switch).
- Check the oil level and for oil leakage. Refer to TM, "Inspection".
Was this page helpful?