Torsion bar
In this manual: Torsion bar
2steps
~12min
1/5difficulty
Done 0 of 2
TORSION BAR : Removal and Installation
REMOVAL
- Remove torsion bar clamp.
- Support trunk lid with a suitable tool.
WARNING: Bodily injury may occur if trunk lid is not supported properly when removing the torsion bars.

3. Apply a torsion bar wrench (A) to torsion bar (1) and lift torsion bar to remove it.
NOTE: For torsion bar wrench, refer to the figure.

INSTALLATION
Installation is in the reverse order of removal.
CAUTION: Check trunk lid open/close operation after installation.
Was this page helpful?