P0603 ECM power supply
In this manual: P0603 ECM power supply
12steps
~72min
3/5difficulty
Done 0 of 12
Description
ECM has the memory function of the DTC memory, the air-fuel ratio feedback compensation value memory, the Idle Air Volume Learning value memory, etc. even when the ignition switch is turned OFF.

DTC Logic
DTC DETECTION LOGIC
| DTC No. | Trouble diagnosis | DTC detecting condition | Possible cause |
P0603 |
ECM BACK UP/CIRCUIT (ECM power supply circuit) | ECM back-up RAM system does not function properly. |
|
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
- Turn ignition switch OFF and wait at least 10 seconds.
- Turn ignition switch ON.
- Turn ignition switch OFF and wait at least 10 seconds.
>> GO TO 2.
2.PERFORM DTC CONFIRMATION PROCEDURE
- Turn ignition switch ON wait at least 10 seconds.
- Turn ignition switch OFF and wait at least 5 minutes
- Turn ignition switch ON, wait at least 10 seconds.
- Repeat step 2 and 3 for five times.
- Check 1st trip DTC.
Is 1st trip DTC detected?
YES >> Go to EC, "Diagnosis Procedure".
NO >> INSPECTION END
Diagnosis Procedure
1.INSPECTION START
- Erase DTC.
- Perform DTC CONFIRMATION PROCEDURE.
Is the 1st trip DTC P0603 displayed again?
YES >> GO TO 2.
NO >> INSPECTION END
2.REPLACE ECM
- Replace ECM. Refer to EC, "Removal and Installation".
- Perform EC, "Work Procedure".
>> INSPECTION END
Was this page helpful?