Low-pressure flexible hose
In this manual: Low-pressure flexible hose
9steps
~54min
2/5difficulty
Done 0 of 9
Removal and Installation
CAUTION: Perform oil return operation before each refrigeration system disassembly. However, if a large amount of refrigerant or oil is detected, do not perform oil return operation. Refer to HA "Perform Oil Return Operation".
REMOVAL
- Use refrigerant collecting equipment (for HFC-134a) to discharge the refrigerant. Refer to HA "Refrigerant Cycle".
- Remove air duct (inlet). Refer to EM "Removal and Installation".
- Remove the engine under cover. Refer to EXT "Removal and Installation".
- Remove low-pressure flexible hose nuts and position lower dash insulator as necessary.
- Remove low-pressure flexible hose bolt and disconnect low-pressure flexible hose from expansion valve.
CAUTION: Cap or wrap the joint of the A/C piping and expansion valve with suitable material such as vinyl tape to avoid the entry of air.
- Remove low-pressure flexible hose bracket nuts and bracket from the vehicle.
- Remove low-pressure flexible hose bolt and disconnect low-pressure flexible hose from the compressor.
CAUTION: Cap or wrap the joint of the A/C piping and compressor with suitable material such as vinyl tape to avoid the entry of air.
- Disconnect vacuum hose from intake manifold. Refer to EM "Exploded View".
- Remove the low-pressure flexible hose.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
- Do not reuse O-rings.
- Apply A/C oil to the O-ring of the low-pressure flexible hose for installation.
- After charging the A/C refrigerant, check for leaks. Refer to HA "Leak Test".
Was this page helpful?