B2626 Outside antenna
In this manual: B2626 Outside antenna
12steps
~72min
3/5difficulty
Done 0 of 12
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
- Turn ignition switch ON.
- Check "Self Diagnostic Result" mode of "BCM" using CONSULT.
Is DTC detected?
YES >> Refer to DLK "Diagnosis Procedure".
NO >> Outside key antenna (LH) is OK.
Diagnosis Procedure
Regarding Wiring Diagram information, refer to DLK "INTELLIGENT KEY SYSTEM : Wiring Diagram".
1.CHECK OUTSIDE KEY ANTENNA INPUT SIGNAL 1
- Turn ignition switch ON.
- Check signal between BCM harness connector and ground using oscilloscope.

Is the inspection result normal?
YES >> Replace BCM. Refer to BCS "Removal and Installation".
NO >> GO TO 2.
2.CHECK OUTSIDE KEY ANTENNA CIRCUIT
- Turn ignition switch OFF.
- Disconnect BCM connector and outside key antenna (LH) connector.
- Check continuity between BCM harness connector and outside key antenna (LH) harness connector.

- Check continuity between BCM harness connector and ground.

Is the inspection result normal?
YES >> GO TO 3.
NO >> Repair or replace harness.
3.CHECK OUTSIDE KEY ANTENNA INPUT SIGNAL 2
- Replace outside key antenna (LH). (New antenna or other antenna)
- Connect BCM connector and outside key antenna (LH) connector.
- Turn ignition switch ON.
- Check signal between BCM harness connector and ground using oscilloscope.

Is the inspection result normal?
YES >> Replace outside key antenna (LH).
NO >> Replace BCM. Refer to BCS "Removal and Installation".
Was this page helpful?