Key switch (BCM Input)
In this manual: Key switch (BCM Input)
3steps
~18min
2/5difficulty
Done 0 of 3
Diagnosis Procedure
Regarding Wiring Diagram information, refer to DLK "Wiring Diagram".
1.CHECK KEY SWITCH INPUT SIGNAL
With CONSULT
Check key switch "KEY ON SW" in DATA MONITOR mode with CONSULT. Refer to BCS "DOOR LOCK : CONSULT Function (BCM - DOOR LOCK)".
- When key is inserted to ignition key cylinder:
KEY ON SW : ON
- When key is removed from ignition key cylinder:
KEY ON SW : OFF
Without CONSULT
Check voltage between BCM connector M18 terminal 37 and ground. 
Is the inspection result normal?
YES >> Key switch (insert) circuit is OK.
NO >> GO TO 2
2.CHECK KEY SWITCH (INSERT)
- Turn ignition switch OFF.
- Disconnect key switch connector.
- Check continuity between key switch terminals.

Is the inspection result normal?
YES >> Repair or replace harness or fuse.
NO >> Replace key switch.
Was this page helpful?