P285A Clutch B pressure
DTC Logic
DTC DETECTION LOGIC
| DTC | Trouble diagnosis name | DTC detection condition | Possible causes |
| P285A | Clutch B pressure disengagement performance | The detection conditions continuously for 200 msec or more under the following diagnosis conditions: - Diagnosis conditions - Selector lever: Other than "P", "R" and "N" positions - Vehicle speed: 10 km/h or more - Engine speed: More than 550 rpm - Output speed: More than 300 rpm - Secondary pulley speed: More than 300 rpm - Command for the 1GR of auxiliary gearbox is in progress. - Auxiliary gearbox shifting is not in progress. - TCM power supply voltage: More than 11 V - Detection conditions - Acceleration/deceleration: Less than −0.05 G - Actual auxiliary gearbox gear ratio − Auxiliary gearbox 1GR ratio ≥ 50% |
- High clutch & reverse brake solenoid valve - Control valve assembly |
| The auxiliary gearbox gear ratio is +-10% or less for the auxiliary gearbox 2GR ratio continuously for 500 msec or more under the following diagnosis conditions: - Diagnosis conditions - Selector lever: Other than "P", "R" and "N" positions - Accelerator pedal position: 0.7/8 or more - Engine speed: More than 550 rpm - Secondary pulley speed: More than 300 rpm - Output speed: More than 300 rpm - Command for the 1GR of auxiliary gearbox is in progress. - Auxiliary gearbox shifting is not in progress. - TCM power supply voltage: More than 11 V |
DTC CONFIRMATION PROCEDURE
CAUTION:
- Be sure to perform "TM "Diagnosis Procedure"" and then perform "DTC CONFIRMATION PROCEDURE".
- Never perform "DTC CONFIRMATION PROCEDURE" before the repairs. Doing so may result in a secondary malfunction.
- Be careful of the driving speed.
1.PREPARATION BEFORE WORK
If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.
>> GO TO 2.
2.CHECK DTC DETECTION
- Start the engine.
- Drive the vehicle.
- Maintain the following conditions for 10 seconds or more.
- Stop the vehicle.
- Check the first trip DTC.
Selector lever : "L" POSITION
Accelerator pedal position : 0.7/8 or more
Vehicle speed : 10 km/h or more
Is "P285A" detected?
YES >> Go to TM "Diagnosis Procedure".
NO >> INSPECTION END
Diagnosis Procedure
1.CHECK INTERMITTENT INCIDENT
Refer to GI "Intermittent Incident".
Is the inspection result normal?
YES >> Replace transaxle assembly. Refer to TM "Removal and Installation".
NO >> Repair or replace malfunctioning parts.