B2098 Ignition relay on stuck
In this manual: B2098 Ignition relay on stuck
~1min read
Description
- IPDM E/R operates the ignition relay when it receives an ignition switch ON signal from BCM via CAN communication.
- Turn the ignition relay OFF by pressing the push-button ignition switch once when the vehicle speed is 4 km/ h (2,5 mph) or less.
- Turn the ignition relay OFF with the following operation when the vehicle speed is more than 4 km/h or when an abnormal condition occurs in CAN communication from the combination meter (Emergency OFF)
- Press and hold the push-button ignition switch for 2 seconds or more.
- Press the push-button ignition switch 3 times within 1.5 seconds.
NOTE: Ignition relay does not turn ON for 3 seconds after emergency OFF even if the push-button ignition switch is pressed.
DTC Logic
DTC DETECTION LOGIC
Diagnosis Procedure
1. PERFORM SELF DIAGNOSTIC RESULT
1. Turn the ignition switch ON.
2. Erase "SELF-DIAG RESULTS" of IPDM E/R.
3. Turn ignition switch OFF, and wait for 1 second or more.
4. Turn the ignition switch ON. Check "SELF-DIAG RESULTS" again.
Is "IGN RELAY ON" displayed?
YES >> Replace IPDM E/R. Refer to PCS "Removal and Installation".
NO >> Refer to GI"Intermittent Incident".
Was this page helpful?