Transmitter wake up operation
Description
This procedure must be performed after replacement of a transmitter or the BCM, or rotation of the wheels.
Work Procedure
NOTE: This procedure must be done after replacement of a TPMS transmitter or BCM. New replacement transmitters are provided "asleep" and must first be "woken up" using Transmitter Activation Tool J-45295 or Signal Tech II Tool J-50190 before ID registration can be performed. Use the following procedure when using the Transmitter Activation Tool J-45295.
NOTE: The Signal Tech II Tool (J-50190) can be used to perform the following functions. Refer to the Signal Tech II User Guide for additional information.
- Activate and display TPMS transmitter IDs
- Display tire pressure reported by the TPMS transmitter
- Read TPMS DTCs
- Register TPMS transmitter IDs
1. Turn the ignition switch ON.
NOTE: The position of an inactive transmitter can be identified by checking the blinking timing of the low tire pressure warning lamp. 
- Place transmitter activation tool (J-45295) (1) against side of tire at location closest to transmitter.
- Press and hold transmitter activation tool button until indicator lamp turns OFF (approximately 5 seconds).
NOTE: Perform wake-up procedure starting from front left wheel, then repeat procedure for front right wheel, rear right wheel, and rear left wheel.
- Check that turn signal lamps blink twice when transmitter wakeup procedure for all wheels is completed.
- Check that low tire pressure warning lamp turns OFF after transmitter wake-up procedure is completed for all wheels.
- Perform the transmitter ID registration procedure. Refer to WT, "ork Procedure".
