Washer nozzle
In this manual: Washer nozzle
~1min read
Washer nozzle : Removal and Installation
REMOVAL
1. Remove cowl top cover. Refer to EXT "Removal and Installation".
2. Disconnect washer tube from washer nozzle (1).
3. Place cowl top cover (2) up side down, then release washer nozzle pawl to remove as shown.

INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
- The spray positions differ, check that left and right nozzles are installed correctly.
- Adjust the nozzle spray pattern. Refer to WW "WASHER NOZZLE : Inspection and Adjustment".
Washer nozzle : Inspection and Adjustment
INSPECTION
Check valve Inspection
Check that air can pass through the nozzle by blowing into the nozzle and that air cannot flow in the opposite direction.

ADJUSTMENT
Washer Nozzle Spray Position Adjustment
Adjust spray positions to match the positions shown.

1. Black printed frame line
: Spray area

1. If washer nozzle (1) spray pattern is not within specification adjust using suitable tool (A).
CAUTION: Do not use needle or small pin to adjust the washer nozzle.
NOTE:
- Washer nozzle adjuster is included with shipment of washer nozzle.
- If wax or dust gets into the nozzle, remove wax or dust with a needle or small pin.

Was this page helpful?