C1607, C1608 EPS Control unit
In this manual: C1607, C1608 EPS Control unit
5steps
~30min
2/5difficulty
Done 0 of 5
DTC Logic
DTC DETECTION LOGIC 
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
>> GO TO 2.
2.DTC REPRODUCTION PROCEDURE
With CONSULT
- Turn the ignition switch OFF to ON.
- Perform "EPS" self-diagnosis.
Is DTC "C1607" or "C1608" detected?
YES >> Proceed to diagnosis procedure. Refer to STC "Diagnosis Procedure".
NO >> Inspection End.
Diagnosis Procedure
1.PERFORM SELF-DIAGNOSIS
With CONSULT
- Turn the ignition switch OFF to ON.
- Erase self-diagnosis results for "EPS".
- Perform "EPS" self-diagnosis.
Is DTC "C1607" or "C1608" detected?
YES >> Replace EPS control unit. Refer to STC "Removal and Installation".
NO >> Check EPS control unit pin terminals for damage or loose connection with harness connector. If any item are damaged, repair or replace malfunctioning component.
Was this page helpful?