P0462, P0463 fuel level sensor
DTC Logic
DTC DETECTION LOGIC
NOTE:
- If DTC P0462 or P0463 is displayed with DTC UXXXX, first perform the trouble diagnosis for DTC UXXXX.
- If DTC P0462 or P0463 is displayed with DTC P0607, first perform the trouble diagnosis for DTC P0607. Refer to EC, "DTC Logic".
This diagnosis indicates the former, to detect open or short circuit malfunction.
| DTC No. | Trouble diagnosis name | DTC detecting condition | Possible cause |
| P0462 | FUEL LEVEL SEN/CIRC (Fuel level sensor circuit low input) | An excessively low voltage from the sensor is sent to ECM. |
|
| P0463 | FUEL LEVEL SEN/CIRC (Fuel level sensor circuit high input) | An excessively high voltage from the sensor is sent to ECM. |
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
- Turn ignition switch OFF and wait at least 10 seconds.
- Turn ignition switch ON.
- Turn ignition switch OFF and wait at least 10 seconds.
TESTING CONDITION: Before performing the following procedure, confirm that battery voltage is between 11 V and 16 V at ignition switch ON.
>> GO TO 2.
2.PERFORM DTC CONFIRMATION PROCEDURE
- Turn ignition switch ON and wait at least 5 seconds.
- Check 1st trip DTC.
Is 1st trip DTC detected?
YES >> Proceed to EC, "Diagnosis Procedure".
NO >> INSPECTION END
Diagnosis Procedure
1.CHECK COMBINATION METER FUNCTION
Refer to MWI, "CONSULT Function" (TYPE A) or MWI, "CONSULT Function" (TYPE B).
Is the inspection result normal?
YES >> Check intermittent incident. Refer to GI, "Intermittent Incident".
NO >> Refer to MWI, "Component Function Check" (TYPE A) or MWI, "Component Function Check" (TYPE B). Check the vehicle type to confirm the service information in MWI section. Refer to MWI, "Information".