P0982 Shift solenoid D
DTC Logic
DTC DETECTION LOGIC
| DTC | Trouble diagnosis name | DTC detection condition | Possible causes |
| P0982 | Shift Solenoid D Control Circuit Low | The following diagnosis conditions are met, and the current monitor reading of the TCM high clutch/low & reverse brake solenoid valve is 200 mA or less continuously for 0.5 seconds or more. - Diagnosis condition - Solenoid valve output current: 750 mA or more - GND short circuit diagnosis occurs in the solenoid valve drive circuit. - TCM power supply voltage: 10 V < TCM power supply voltage < 16 V |
- Harness or connector (Short circuit to ground in the high clutch/low & reverse brake solenoid valve circuit) - High clutch/low & reverse brake solenoid valve |
DTC CONFIRMATION PROCEDURE
CAUTION: Be careful of the driving speed.
1.PREPARATION BEFORE WORK
If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.
>> GO TO 2.
2.CHECK DTC DETECTION
- Drive the vehicle.
- Maintain the following conditions for 5 seconds or more.
Selector lever : D position
Gear : 3GR, 4GR
Vehicle speed : 45 km/h or more
- Stop the vehicle.
- Check the first trip DTC.
Is "P0982" detected?
YES >> Go to TM, "Diagnosis Procedure".
NO >> INSPECTION END
Diagnosis Procedure
1.CHECK CIRCUIT BETWEEN TCM AND A/T UNIT
- Turn ignition switch OFF.
- Disconnect the TCM connector and A/T unit connector.
- Check the continuity between TCM harness connector and ground.

Is the check result normal?
YES >> GO TO 2.
NO >> Repair or replace the malfunctioning parts.
2.CHECK HIGH CLUTCH/LOW & REVERSE BRAKE SOLENOID VALVE
Check the high clutch/low & reverse brake solenoid valve. Refer to TM, "Component Inspection (High Clutch Solenoid Valve)".
Is the check result normal?
YES >> Check intermittent incident. Refer to GI, "Intermittent Incident".
NO >> Repair or replace the malfunctioning parts.
Component Inspection (High Clutch Solenoid Valve)
1.CHECK HIGH CLUTCH/LOW & REVERSE BRAKE SOLENOID VALVE
Check the resistance between the A/T unit connector and ground. 
Is the check result normal?
YES >> INSPECTION END
NO >> There is a malfunction of the high clutch/low & reverse brake solenoid valve. Replace the transaxle assembly. Refer to TM, "Removal and Installation".