High-pressure pipe
In this manual: High-pressure pipe
~1min read
Removal and Installation
CAUTION: Perform oil return operation before each refrigeration system disassembly. However, if a large amount of refrigerant or oil is detected, do not perform oil return operation. Refer to HA "Perform Oil Return Operation".
REMOVAL
- Remove low-pressure flexible hose. Refer to HA "Removal and Installation".
- Disconnect high-pressure pipe from expansion valve.
CAUTION: Cap or wrap the joint of the A/C piping and expansion valve with suitable material such as vinyl tape to avoid the entry of air.
- Remove high-pressure pipe bolt and disconnect high-pressure pipe from the condenser.
CAUTION: Cap or wrap the joint of the A/C piping and condenser with suitable material such as vinyl tape to avoid the entry of air.
- Loosen the clip and remove high-pressure pipe from the vehicle.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
- Do not reuse O-rings.
- Apply A/C oil to the O-ring of the high-pressure pipe for installation.
- After charging the A/C refrigerant, check for leaks. Refer to HA "Leak Test".
Was this page helpful?