Diagnosis and repair work flow
Work Flow
NOTE: The Signal Tech II Tool (J-50190) can be used to perform the following functions. Refer to the Signal Tech II User Guide for additional information.
- Activate and display TPMS transmitter IDs
- Display tire pressure reported by the TPMS transmitter
- Read TPMS DTCs
- Register TPMS transmitter IDs
1.COLLECT INFORMATION FROM CUSTOMER
Get detailed information from the customer about the symptom (the condition and the environment when the incident/malfunction occurred).
>> GO TO 2.
2.TIRE PRESSURE INSPECTION
Check the tire pressure for all wheels. Refer to WT "Tire Air Pressure".
Is the inspection result normal?
YES >> GO TO 3.
NO >> Repair or replace tire(s) or wheel(s).
3.CHECK LOW TIRE PRESSURE WARNING LAMP
Check that the low tire pressure warning lamp illuminates for approximately 1 second after the ignition switch is turned ON, then turns OFF.
Does the low tire pressure warning lamp turn OFF?
YES >> Inspection End.
NO >> GO TO 4.
4.PERFORM SELF DIAGNOSTIC RESULT
Perform self diagnostic result. Refer to BCS "AIR PRESSURE MONITOR : CONSULT Function (BCM - AIR PRESSURE MONITOR)" or BCS "AIR PRESSURE MONITOR : CONSULT Function (BCM - AIR PRESSURE MONITOR)".
Are any DTCs displayed?
YES >> Refer to BCS "DTC Index" or BCS "DTC Index". If two or more DTCs are displayed, refer to BCS "DTC Inspection Priority Chart" or BCS "DTC Inspection Priority Chart".
NO >> GO TO 5.
5.PERFORM DIAGNOSIS APPLICABLE TO THE SYMPTOM
Perform diagnosis applicable to the symptom. Refer to WT "Symptom Table".
>> GO TO 6.
6.FINAL CHECK
Perform self diagnostic result again, and check that the malfunction is repaired. After checking, erase the self diagnosis memory. Refer to BCS "AIR PRESSURE MONITOR : CONSULT Function (BCM - AIR PRESSURE MONITOR)" or BCS "AIR PRESSURE MONITOR : CONSULT Function (BCM - AIR PRESSURE MONITOR)".
>> Inspection End.