Preparation
In this manual: Preparation
~2min read
Special Service Tools
The actual shapes of KentMoore tools may differ from those of special service tools illustrated here.
| Tool number (KentMoore No.) Tool name | Description |
KV10111100 (J37228) Seal cutter ![]() |
Removing oil pan (lower and upper) etc. |
KV10116200 (J26336B) Valve spring compressor 1. KV10115900 (J2633620) Attachment 2. KV10109220 ( - ) Adapter ![]() |
Disassembling and assembling valve mechanism Part (1) is a component of KV10116200, but Part (2) is not so. |
KV10112100 (BT8653A) Angle wrench ![]() |
Tightening bolts for main bearing cap, cylinder head, etc. |
KV10117100 ( - ) Heated oxygen sensor wrench ![]() |
Loosening or tightening heated oxygen sensor 1 For 22 mm (0.87 in) width hexagon nut |
KV10107902 (J38959) Valve oil seal puller ![]() |
Removing valve oil seal |
KV10115600 (J38958) Valve oil seal drift ![]() |
Installing valve oil seal Use side A. a: 20 (0.79) dia. d: 8 (0.31) dia. b: 13 (0.51) dia. e: 10.7 (0.421) c: 10.3 (0.406) dia. f: 5 (0.20) Unit: mm (in) |
EM03470000 (J8037) Piston ring compressor ![]() |
Installing piston assembly into cylinder bore |
ST16610001 (J23907) Pulley puller ![]() |
Removing pilot converter |
KV11103000 ( - ) Pulley puller ![]() |
Removing crankshaft pulley |
KV11105210 (J44716) Stopper plate ![]() |
Holding drive plate and flywheel static |
Commercial Service Tools
| Tool name | Description |
Power tool ![]() |
Loosening nuts, screws and bolts |
Quick connector release ![]() |
Removing fuel tube quick connectors in engine room |
Spark plug wrench ![]() |
Removing and installing spark plug a: 14 mm (0.55 in) |
Pulley holder ![]() |
Crankshaft pulley removing and installing |
Valve seat cutter set ![]() |
Finishing valve seat dimensions |
Piston ring expander ![]() |
Removing and installing piston ring |
Valve guide drift ![]() |
Removing and installing valve guide |
Valve guide reamer ![]() |
(1): Reaming valve guide inner hole (2): Reaming hole for oversize valve guide |
(J4389718) (J4389712) Oxygen sensor thread cleaner ![]() |
Reconditioning the exhaust system threads before installing a new air fuel ratio sensor (Use with antiseize lubricant shown below.) A: [18 mm (0.71 in) dia.] for zirconia heated oxygen sensor B: [12 mm (0.47 in) dia.] for titania heated oxygen sensor C: Mating surface shave cylinder D: Flutes |
Acoustic tension gauge ![]() |
Checking drive belt tension |
Antiseize lubricant (Permatex 133AR or equivalent meeting MIL specification MILA907) ![]() |
Lubricating oxygen sensor thread cleaning tool when reconditioning exhaust system threads |
Manual lift table caddy ![]() |
Removing and installing engine |
1. Compression gauge 2. Adapter ![]() |
Checking compression pressure |
Tube presser ![]() |
Pressing the tube of liquid gasket |
Was this page helpful?























