1st Gear One-Way Clutch Inspection
In this manual: 1st Gear One-Way Clutch Inspection
2steps
~12min
1/5difficulty
Done 0 of 2
Inspection
1. 1st Gear One-Way Clutch - Assemble

- Install the 53 x 57 x 20 mm needle bearing (A) and 1st gear(B) on the park gear (C).
2. 1st Gear One-Way Clutch - Inspect

- Hold the park gear (A), and turn 1st gear (B) in the directionshown to be sure it turns freely. Also make sure 1st gearlocks in the opposite direction.
- If any problem occurs on the 1st gear one-wayclutch,replace 1st gear.
NOTE: The 1st gear one-way clutch is not available separately from 1st gear.
Was this page helpful?