D4 Switch Test
In this manual: D4 Switch Test
3steps
~18min
2/5difficulty
Done 0 of 3
Test
SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repair or service.
1. Center Console - Remove
2. D4 Switch - Continuity Test

- Remove the harness wire tie (A).
- Disconnect the connector (B).
- Check for continuity between D4 switch connector terminals No. 1 and No. 2. There should be continuity while pressing the D4 button and no continuity when the D4 button is released.
- If the D4 switch test is OK, the test is finished.
- If the D4 switch test fails, replace the D4 switch.
3. All Removed Parts - Install
- Install the parts in the reverse order of removal.
Was this page helpful?